RT Journal Article
SR Electronic
T1 76 Effects of concrete bit wear on drill handle vibration, drilling productivity and changes in bit tip geometry
JF Occupational and Environmental Medicine
JO Occup Environ Med
FD BMJ Publishing Group Ltd
SP A525
OP A525
DO 10.1136/oemed-2018-ICOHabstracts.1486
VO 75
IS Suppl 2
A1 Rempel, David
A1 Antonucci, Andrea
A1 Botti, Lucia
A1 Mora, Cristina
A1 Martin, Bernard
A1 Barr, Alan
YR 2018
UL http://oem.bmj.com/content/75/Suppl_2/A525.1.abstract
AB Introduction The use of hammer drills for concrete drilling exposes construction workers to high levels of hand vibration that may lead to hand arm vibration syndrome and other musculoskeletal disorders. The aim of this study was to investigate the effects of concrete bit wear on drill handle vibration, productivity, and change in bit shape.Methods A laboratory test bench system was used to automatically advance an active 8.3 kg hammer drill with a 1.9 cm diameter carbide-tipped bit into aged concrete block under feed force control to a depth of 7.5 cm while drill handle vibration (ISO 5349 and 28927) and penetration rate (mm/s) were measured. Bits were worn to 4 levels by consecutively drilling holes to cumulative depths of 0, 1900, 5700 and 7600 cm. Image analysis methods quantified 13 geometric parameters of the carbide tip. Changes in the geometric parameters were compared to changes in penetration rate.Result Z-axis handle vibration increased significantly (p<0.05) from 4.8 to 5.1 m/s2 (ISO weighted) and from 42.7 to 47.6 m/s2 (unweighted) when comparing a new bit to a bit worn to 1900 cm of cumulative drilling depth, but did not increase further with more wear. Drilling time increased by 58% for the worn (5700 cm) bit compared to a new bit. Changes in bit shape highly correlated to reduced productivity were increased fluke slope, increased shoulder rounding, and decreased tip width.Discussion Carbide-tipped bit wear was associated with a small increase in ISO weighted and unweighted z-axis handle vibration and a large decrease in drilling productivity. To reduce drill-handle vibration levels and exposure time to hand vibration, construction contractors should implement a bit replacement program guided by bit wear. Other controls, such as exposure time per day, may also be necessary to adequately protect workers from hazardous levels of hand vibration.